How do I align my display holder?

The alignment of the support arm can be adjusted in all directions by opening the screw on the handlebar clamp. Once the desired alignment has been set, the screw can be tightened again (max. torque: 1.5 Nm).
It is also possible to adjust the angle of the on-board computer. To do this, loosen the screw on the side of the holding arm and set the desired angle of the on-board computer. Due to the locking mechanism, the angle can only be adjusted in increments of about 20°. After the right position has been found, the screw is secured again (max. torque: 1.5 Nm).

Back to overview