Back

How do I align my display mount?

Opening the screw on the handlebar clamp lets you align the support arm in all directions. Once the desired alignment has been set, the screw is retightened (max. torque: 1.5 Nm).
It is also possible to adjust the angle of tilt of the on-board computer. To do this, loosen the screw on the side of the holding arm and set the desired angle of tilt of the on-board computer. Because of the locking mechanism, the angle can only be adjusted in increments of about 20°. After the right position has been found, the screw is retightened (max. torque: 1.5 Nm).

Tell a friend

Share link

Any questions?
We're happy to help.

Contact

Help Center

Any questions?
We're happy to help.

Contact